Randy Sanchez

Move steps 2 & 4 in sequence between steps 10 & 11.

Change picture to highlight FEED STOP and not FEED START

And cable lengths are different

Need to change location of turret drive, left.

Add spindle orientation check with service code 510.

Let’s try and get a new picture of a 24999 break out box, also without jumpers, it will look cleaner.

Change the wording from “wires” to “cables”.

Insert a bullet before where it says to run code 128, have it say “machine must be calibrated using service code 123 and a calibration standard or other precision block”.

Completed suggested changes.

In the introduction, remove machine model (K3). Just simply say “how to replace the computer module of a ProtoTRAK SMX CNC”