-
-
Enter Service code 521 on the Pendant, the control will prompt you to save and close any work open before you press OK. Press the connect button. "Not Connected" box to left of "Connect" button should now disappear. Choose appropriate product from drop down menu.
-
There could be up to a 10 second delay before hardware tester can used.
-
Select NC Ready, NC Ready 2 and Motion Allowed. Press RESET button on lower right corner of Pendant. This will allow the technician to run the axis and spindle and activate other outputs in this mode.
-
All INPUTS will have a circle adjacent to text as opposed to a square, which would indicate an output.
-
Physically activate any Input (ie; e-stop), look at corresponding input selection on screen and you should see the circle filled in.
-
If input does not change state, disassembly of input device may be required and use of a multimeter may be needed to determine fault.
-
Cancel: I did not complete this guide.
One other person completed this guide.
