Field Installation Procedure - Mills Lamp Option

Written By: Trent Plungas
  • Comments: 0
  • Favorites: 0

Difficulty

Easy

Steps

4

Time Required

00:15:00 - 00:30:00

Sections

1

  1. The mounting location is shown for the lamp. The Work Lamp Assembly29066 is mounted to a Spacer 23395-1 into holes drilled by the assembler. This drawing shows where the holes are drilled as well as order of assembly of the Work Lamp. This photo shows the Lamp wire joins other tie wrapped cable along the outside of the mill casting.

    • The mounting location is shown for the lamp. The Work Lamp Assembly29066 is mounted to a Spacer 23395-1 into holes drilled by the assembler. This drawing shows where the holes are drilled as well as order of assembly of the Work Lamp.

    • This photo shows the Lamp wire joins other tie wrapped cable along the outside of the mill casting.

  2. The mounting location is shown for the lamp. The Work Lamp Assembly29066 is mounted to a Spacer 23395-1 into holes drilled by the assembler. This drawing shows where the holes are drilled as well as order of assembly of the Work Lamp. Work Lamp assembly detail. This photo shows the Lamp wire joins other tie wrapped cable along the outside of the mill casting.

    • The mounting location is shown for the lamp. The Work Lamp Assembly29066 is mounted to a Spacer 23395-1 into holes drilled by the assembler. This drawing shows where the holes are drilled as well as order of assembly of the Work Lamp.

    • Work Lamp assembly detail.

    • This photo shows the Lamp wire joins other tie wrapped cable along the outside of the mill casting.

  3. Cable enters the bottom of the electric cabinet, and gets routed along the right wire way. If Work Lamp cable is too short to be routed along the side of the cabinet, route cable along the right wire way. Electric cable plugs into "OUT-LIGHTS" location on the computer module.

    • Cable enters the bottom of the electric cabinet, and gets routed along the right wire way.

    • If Work Lamp cable is too short to be routed along the side of the cabinet, route cable along the right wire way.

    • Electric cable plugs into "OUT-LIGHTS" location on the computer module.

  4. Use existing holes to mount the Work Lamp Kit.

    • Use existing holes to mount the Work Lamp Kit.

    • Power cable is run along with the motor wires and plugs into the side of the electric box.

Finish Line

Author

Trent Plungas

Member since: 01/14/2021

64 Guides authored

Team

Siemens Internal Member of Siemens Internal

50 Members

28 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 2

Past 7 Days: 2

Past 30 Days: 7

All Time: 64