Reputation over time
It looks like this user hasn't gained any reputation yet.
Once they have, you'll be able to view a graph of their reputation gained over time.
Here's a preview of what the graph will look like:
Reputation Breakdown
No reputation gained yet.
24
First bullet - “Insert Plunger # 20 and place flush to top of base,”
The rest of this bullet should go on step 9, between the 2 red bullets.
I need to have you add a note about the end stops. I will email you a picture. The TMC 12/14 door opening is wide, and the bumpers stop the X/Y EHW from being pushed off the railing and falling off.
Show this with a picture. Are these the checks we have in the other guide as well?
Update the picture.
Text - “Feed the EHW cable 21774-1 from the outside into the opening at about the center of the panel. Tighten the liquid tight fitting. The electric cable connects to 31209 mount at the top inside of the panel. You can access the connector from the outside of the spindle without removal of the right side cover by fully lowering the Z axis.”
First step - add step - Plug in proximity sensors
Then resume with current first step as second step.
Second bullet - “Attach Dovetail Base to Spindle Side Cover using the required hardware listed on the Parts List. “
We do not attach the Z EHW until the whole slider assembly is built.
Third bullet - If the plunger is installed from back, it needs to be installed when we install the prox sensors. That would be best time. All black bullets move together.
Last green bullet - this is connecting the prox sensors - why is this down here? We’ve already connected them.
Information icon - this goes with the black bullets. Condense this information.
1st bullet - there are 6 PEM nuts pre-installed…
2nd image - Can you balloon over the 27635-98 and make it 27635-238?
Last bullet - This is repetitive. We’ll just tell them what to do in the next step.
Flip the labels in second picture - it is X then Y.
We will tell them this, and then add indent bullet - “If connectors are reversed, swap connections at the electrical cabinet”
1st red bullet - add indent bullet - “if no label, skip this step”
Picture can be removed from step 10. It is only needed on step 4.
This looks good here.
Page 1 of 6
Next