Skip to main content

Introduction

← TRAKsi Tech Support: start here

Use this when the magazine position no longer matches the control. For example, the magazine is at Pot Station #6 but the control shows Pot Station #20.

This guide homes the magazine back to Pot Station #1. No password needed.

Other TRAKsi Tech Support guides: Software Version · Screenshot · Alarm Log · Archive · Diagnostic File (DiDac) · Button-Press Log

  1. Close the machine doors. The magazine rotates in the next bullet. Keep hands clear. On the MCP, turn on [JOG] and [REF. POINT].
    • Close the machine doors.

    • The magazine rotates in the next bullet. Keep hands clear.

    • On the MCP, turn on [JOG] and [REF. POINT].

    • Press and hold [MAG], then press [+].

    • The magazine rotates until Pot Station #1 is in line with the spindle.

  2. Press [Tool List] (left side, second button from the top). Confirm the correct tool is listed at Location #1.
    • Press [Tool List] (left side, second button from the top).

    • Confirm the correct tool is listed at Location #1.

    • Green arrows also show at Location #1, as in the photo.

    • If the wrong tool is at Location #1, stop and contact TRAK Tech Support.

Finish Line

One other person completed this guide.

Pat Fitzsimmons

Member since: 3/1/21

27 Guides authored

0 Comments

Add Comment



View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 317