Introduction
Occasionally, the magazine position becomes out-of-synch with the control display. An example of this situation would be if the ATC is currently sitting at ATC Pot Station #6, but the control incorrectly identifies its location to ATC Pot Station #20.
This guide details how to home the ATC back to ATC Pot Station #1.
-
-
Close the machine doors.
-
Turn on both the JOG and REF. POINT buttons on the MCP.
-
Press and hold the MAG button, and then also press the "+" button on the MCP.
-
Doing so causes the magazine to rotate until ATC Pot Station #1 is in line with the spindle.
-
-
-
On the touchscreen, press the second left-side bar shortcut key (Tool list). The "Tool list" window will appear.
-
Confirm if the correct tool is listed under Location #1 on the "Tool list" window.
-
In addition, green arrows should also appear under Location #1, as shown on the image.
-
Cancel: I did not complete this guide.
One other person completed this guide.
