Skip to main content
  1. Power off machine before removing any cables. Remove the 8 screws from the rear pendant casing.
    • Power off machine before removing any cables.

    • Remove the 8 screws from the rear pendant casing.

    • Disconnect the following cables: Estop cables, Toolroom vs Production Operations cable, Front panel Handwheel cables and Overlay ribbon cables.

    • Remove the 7 bolts that hold the Run Panel.

    • Install the replacement part and perform previous steps in reverse order.

    • Power on machine and verify the Run panel functions.

Finish Line

Fataimoemanu Tohi

Member since: 02/11/2020

12 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 2

All Time: 67