Skip to main content
  1. Prior to powering off the machine, save configuration files if needed. Do not remove cables or unmount parts while the machine is ON. Machine must be TURNED OFF to continue to the next step. Unbolt the 8 screws from the rear pendant casing. If the panel has a memory option and/ or options key, these items must be removed and installed into the replacement part.
    • Prior to powering off the machine, save configuration files if needed. Do not remove cables or unmount parts while the machine is ON. Machine must be TURNED OFF to continue to the next step.

    • Unbolt the 8 screws from the rear pendant casing.

    • If the panel has a memory option and/ or options key, these items must be removed and installed into the replacement part.

    • Disconnect the following cables: 4-USB cables, Audio jack, Run Panel overlay cable, DB-25 Umbilical cable, E-stop wire cable and RSG.

    • Remove the 8 bolts that hold the programming panel.

    • Install the replacement part and perform previous steps in reverse order.

    • Power on machine, load configuration files and recalibrate if needed.

Finish Line

Fataimoemanu Tohi

Member since: 02/11/2020

12 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 1

All Time: 125