-
-
Parts Requirements:
-
Two (2) USB Emulator Drives (PN: 27702-1) come with ten (10) screws, and three (3) small white cable ties.
-
If single floppy drive then one (1) USB Emulator Drive comes with five (5) screws, and three (3) small white cable ties.
-
Remove the computer out of the cabinet as shown.
-
Remove four (4) screws (A, B, C, D) as shown to remove the front panel.
-
-
-
Remove six (6) screws that hold the floppy drives as shown.
-
Disconnect the power cables and floppy cable from the floppy drives assembly and install the USB emulator drives as shown.
-
Connect Floppy Drive Cable, and Power Cables into the USB Emulator Drives as shown.
-
-
-
Install the USB Emulator Assembly with six (6) screws into computer.
-
Organize the floppy drive cable with 3 cable ties as shown.
-
Verify USB Emulator Drives are installed as shown. Close the front cover with four (4) screws.
-
Cancel: I did not complete this guide.
2 other people completed this guide.
Team
