-
-
Enter Service code 521 on the Pendant, the control will prompt you to save and close any work open before you press OK. Press the connect button. "Not Connected" box to left of "Connect" button should now disappear. There may be up to a 10 second delay before you can use the hardware tester. Select product type from drop down menu.
-
Select NC Ready, NC Ready 2 and Motion Allowed. Press RESET button on lower right corner of Pendant. This will allow the technician to run the axis and spindle and activate other outputs in this mode.
-
Select Output by selecting box next to desired OUTPUT.
-
All OUTPUTS will have a square adjacent to text as opposed to a circle, which would indicate an INPUT.
-
If OUTPUT does not turn on, further troubleshooting will be necessary.
-
